Circle Slider Card

 The slider panel is a great way to gift a gift card or even cash. This one will have money in for my sister on her birthday, No special dies needed

There is a video up on my YouTube Channel

Card Making Supplies

Paper Craft Society Box 50

Momento Dew Drops in Lilac Posies

Nuvo Drops in Heritage Rose and Wedgewood Blue

Made To Surprise Push Me Pull Me Stamp Set

Made To Surprise Lets Hear It For The Girls Sentiment Stamp Set

Circle Punch

Circle Cutter

Staz On Royal Purple Ink

Card Making Instructions

Fold a sheet of A4 in half. Make a mark 2 3/4 inch from the fold Set the circle cutter to 3 inch radius and use the mark you just created as the centre. Cut the card base

Keeping the circle cutter the same size cut another circle in the same coloured card. This was glued over the front of the card 

Set the circle cutter to a radius of 2 3/3 and cut a second circle to act as a mat

A piece of white was then cut using the circle cutter which had a radius of 2 1/2 inch. Using a circle punch I create a finger hole for the pull tab

Using the same size mat and layer create an insert for the inside of the card

Take a strip of card measuring 3 1/2 by 4 1/2. On the 2 longest sides score 1/2 inch in and 4 inch down. Then trim this away

With the 2 tabs at the bottom, place this piece as low down on the white card as you can without seeing it from the front. Trace around the top and trim this away

A strip of white card measuring 3 1/2 by 3 1/2 inch is used to create the pocket

This was scored at 3/4 inch on the two longest sides and one of the short sides. With the short edged which is scored at the bottom, trim up the score line approximately half way

The tabs were turned over and this was glued onto the slider panel, with the opening at the curved end

A strip of card measuring 5 by 1 was scored at 1 and 4 inch, these were folded over and glue applied to the tabs. Before being glued onto the back of the white panel

The slider panel is threaded through this

The Pull stamp was stamped onto the top of the slider panel using the Staz on ink

Foam tape is placed at the bottom to prevent the tab from falling out and then carefully around the edge. Be care to ensure that the tab can still be pulled up! This was then adhered onto the card base.

The donut was stamped 3 times, coloured and fussy cut out. 2 were glued on and one added foam tape. The sentiment was stamped in the moment dew drop

The panel was then finished with the nuvo drops

Thank you for reading